Flanged Axial Location

The precision-ground flange face registers directly against the housing shoulder, providing positive axial location without snap rings or adhesive retention.

GCr15 Chrome Steel

Through-hardened to HRC 58–64. Ball tracks ground to Ra 0.2 µm for full-film lubrication at the ball-race contact under rated load conditions.

Dynamic Load 206–1570 N

Covering 9 bore sizes for applications from lightweight instrument stages to heavy industrial press guides.

NBR Dual Lip Seals

Retain factory-applied NLGI-2 grease while excluding dust and contamination. Rated −20°C to +80°C continuous service.

PA66-GF30 Retainer

Glass-filled nylon cage maintains precise ball spacing across the full 360° circuit, preventing ball-to-ball contact and associated noise.

ISO/DIN Interchangeable

All dimensions conform to ISO Square Flange standards for direct replacement compatibility with equivalent housings.

Medical Device Manufacturing

Square-flange (LMH/LMHP) bearings are preferred in syringe pump drives and diagnostic cartridge dispensers because the flat flange face seals cleanly against the housing wall, reducing contamination pathways in sterile manufacturing environments.

Food & Beverage Processing

Flanged bearings in filling-nozzle platforms and portioning conveyors allow rapid cartridge replacement during product changeovers; the flange retains the bearing against the housing face without tools, reducing changeover time.

🔎 Flange Face Seating

Ensure the housing counterbore depth matches the bearing flange thickness. An under-depth counterbore leaves the flange proud of the housing face, creating a gap at the bolt interface that allows the bearing to rock under load and introduces harmonic error motion.

🔧 Bolt Torque Sequence

Tighten flange mounting bolts in a cross pattern to 30–50% of final torque, then complete to specification. Sequential tightening distorts the flange and shifts the bore axis by up to 0.05 mm, degrading shaft alignment.

📈 Housing Bore Tolerance

Machine the housing bore to H7 tolerance. For square-flange (LMH/LMHP) variants, also verify the flange seating face is square to the bore within 0.02 mm to prevent cocking the bearing on assembly.

⚙ Lubrication

Apply NLGI-2 lithium-complex grease to the shaft before insertion. Re-lubricate every 500 km of travel or 6 months under normal duty. In washdown environments, shorten the re-lubrication interval and use a water-resistant grease formulation.

①

Confirm Bore & Standard

Match bore diameter to shaft. Confirm ISO Square Flange housing dimensions — mixing ISO and DIN outer diameters requires housing re-machining.

②

Select Flange Style

Round flange for maximum moment resistance; diamond flange for compact bolt clearance; square flange for torsional resistance.

③

Calculate Load & Life

Compute radial load P. Target L10 = (C/P)³ × 50 km. If life is marginal, specify the LUU extended variant to raise C without changing bore.

④

Contact Us

MOQ 100 units per model. Contact our team with engineering drawings confirming shaft diameter, housing bore depth, bolt PCD, load case, and target life.

📞 Ready to Order?

MOQ is 100 units per model. Provide engineering drawings with shaft diameter, housing bore depth, flange PCD, load case, stroke, speed, and target life. All catalogue data is for reference only — verify critical dimensions against current revision drawings before committing to tooling.